Step 1
Unplug The Clipper! Remove the clipper blade. Remove the clipper drive assembly service cap. |
Step 2
Remove the two Phillips screws that are holding the drive assembly. Remove ONLY the screws. Locate the rear plastic tab on your clipper attachment. Place the attachment on the clipper in the place of the drive assembly cover plate. |
Step 3
Tilt the head toward the back of the clipper and push to insert rear tab into the clipper housing. After inserting tab, tilt the head forward into place. Install enclosed screws. Do not over tighten! Make sure that the screw heads are completely touching the clipper attachment. Reinstall the clipper blade. |
