Step 1
Unplug the clipper! Pull out the clipper blade and gently lift up to remove. |
Step 2
Remove the screws from the bottom of the clipper housing. Turn screwdriver to the left to unscrew. Notice that two large screws go in the front and the two smaller screws go in the back of the clipper. |
Step 3
Gently lift up the top portion of the clipper housing and remove. Be careful not to disturb the interior clipper parts. Remove top portion of the clipper housing. Make sure the interior parts were not disturbed, and the cord end is in its correct slot. |
Step 4
Gently place your new clipper attachment in place of the top portion of the clipper housing. Make sure the cord end is inserted in its correct position. The clipper attachment should set right into place. Replace large screws in the top portion of the clipper and the small screws in the bottom portion. |
Step 5
When tightening bottom screws. Be sure not to over tighten. Only tighten until the top and the bottom portion of the clipper housing are completely flush. Replace clipper blade and push blade toward clipper to lock in place.
|
Let us know how this installation procedure
worked for you! |
